Filter
Top Products
1
2
3
1
,—.-___
Press CLOCK, then press II SET within 4
seconds.
When using the remote control
Press CLOCK whilepressingSHIFT, then press II SET-
4 seconds,
Press -44 DOWN or - UP to designate the
hour, then press 11 SET.
The hour stops flashing and the minute starts flashing,
Press -d< DOWN or > UP to designate the
minute, then press 11 SET.
The minulestopsflashingonthedisplayandtheclockstarts
from 00 seconds,
To display the current time
Press CLOCK. The time is displayed for 4 seconds,
However, the time cannot be displayed during recording,
To switch to the 24-hour standard
Press the CLOCK and then press
❑ within 4 seconds,
Repeat the same procedure to restore the 12-hour standard.
~’
This is caused by a power interruption. The current time needs
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
‘
ENTER is ako avai/ab/e instead of II SET.
* MULTI JOG is also available instead of 44 and W.
--du
The unit can be turned off automatically at a specified time,
Use the remote control,
1
Press SLEEP while pressing SHIFT.
2 Within 4 seconds, press + or > to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time
is displayed
for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEP oFF”
appears on the display,
‘ MULTI JO,G is also available instead of M and W.
ENGLISH
18