Filter
Top Products
II
,,
. .
Use Type I (normal) tapes only.
7
Press TAPE and press A
cassette holder.
EJECT to open the
A EJECT
Insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press 4>
to start play.
The selected deck number The tape counter indicates
L,
the tape running length.
To select a playing deck
When tapes are loaded in both decks, press TAPE first to select
a deck.
The selected deck number is displayed.
To stop play, press ■ .
To pause play (deck 2 only), press 1I. To resume play, press
again.
To change the playback side (deck 1 only), press <> in play
or pause mode.
To fast forward or rewind, press < or -. Then press W
to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE. The power is turned on and play of the inserted
tape begins.
To set the tape counter to 0000
Press S CLEAR in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
When tapes are loaded in both decks
After playback of both side (front and back) on deck 1 finishes,
the tape in the deck 2 will start to play without interruption and
will stop at the end of the front side of the tape. (Continuous
play)
.,--,,,,,;.: ... .-i=-
... ~--~-:=%.==-..,..:
!?,!,: w *,’,, L *W
MUSIC SENSOR “(deck-l-only)
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press + or - during playback referring to the playback side
indicator (< or E) on the display,
For example, when - is pressed while P is displayed,
playback of the next track starts after searching.
Music sensor function may not be able to detect tracks under
the following conditions:
● Blanks of less than 4 seconds between tracks
● Noisy blanks
● Long passages of low-end sound
● Low overall recording levels
Playback side indicator
-: The front side is being played (forward).
<: The back side is being played (reverse).
11 ENGLLSH