System Administrator’s Guide to Installing DataMgr
2-6 Installation
Install
DataMgr
If the various components are going to be installed on different
machines, the installation sequence is as follows:
• SLD.
• BFS.
• SSD.
• DMFS.
ADIC recommends that each component be started before the
next component is installed. This will ensure that each
component can talk to the others correctly.
From each machine listed in “Complete Table” on Page 1-17,
perform the installations steps below:
Note
The SLD component should be installed first and must
be running when the DMFS is installed. This only
applies if the two components are located on different
machines.
Caution
The installation script inserts entries into various system files.
These entries are encapsulated between special tags. A
typical tag will appear like %CDVSTART_dmfs%. Do not alter or
remove these tag lines.
Caution
If you are upgrading DataMgr, make sure you have a
successful current backup of your BFS Database.