Filter
Top Products
56
ZETA Music Systems, Inc.
ZMC-200 Manual Rev2.0
Possible problem: Your external MIDI instrument is not set to XG/General
MIDI mode or does not support this standard.
Solution:
1. Set your MIDI instrument to GM mode. Set the ZETA
SYNTHONY II’s parameter for preset names to “GM” (see
UTILITY MODE).
2. If your MIDI instrument doesn’t support these standards, set your
ZETA SYNTHONY II’s preset names parameter to “NUM”. You
can now access the desired sound using the corresponding MIDI
bank and program number.
SYSTEM EXCLUSIVE IMPLEMENTATON
F0H - Exclusive status
00H - European ID's
20H - European ID's
2DH - BCM ID
20H - Model ID AX100
00H - Device ID
ah - Address high
am - Address mid
al - Address low
ch - Byte Count high
cm - Byte Count mid
cl -Byte Count low
dh - Data #0 high 7 bits
dl - Data #0 low 7 bits
... - Data ...
... - Data ...
dh - Data #n high 7 bits
dl - Data #n low 7 bits
cc - Checksum
F7H - End of exclusive
The following dumps are presently supported:
Total dump
Presetdump (All, 1...128)
Chaindump (All, 1...32)
Patterndump for Arpeggiator (All, 1...16)
Total Effectdump (Rev setup, all revs, chor setup, all chors, var setup, all
vars)
Reverbdump (Rev setup, all reverb programs)
Chorusdump (Chor setup, all chorus programs)
Variationdump (Var setup, all variation programs)