ZETA Music Systems ZMC-200 Speaker System User Manual


 
24
ZETA Music Systems, Inc.
ZMC-200 Manual Rev2.0
II will only send Controller 10 if the panorama settings have changed from
what was previously sent, so as not send redundant information.
REV ENABLE
Reverb Controller (ON/OFF)
For the same reasons (see PAN ENABLE), you may not want MIDI
Controller #91 information (Reverb) for a preset split sent to your MIDI
instruments. Set this value to OFF. NO EFFECT, is also listed as a choice.
If this is selected, the programmed reverb function of the preset will be
ignored by the soundboard.
CHOR ENABLE
Chorus Controller (ON/OFF)
Here you determine whether MIDI Controller #93 (Chorus) will be sent to
your MIDI instruments or not. (see PAN ENABLE) A third parameter, NO
EFFECT, is also listed as a choice. If this is selected, the programmed
chorus function of the preset will be ignored by the soundboard.
VAR ENABLE
Variation Controller (ON/OFF)
Here you determine whether MIDI Controller #94 (Variation) will be sent
to your MIDI instruments or not. (see PAN ENABLE) if your ZETA
SYNTHONY II is equipped with the internal soundboard, a third
parameter, NO EFFECT, is also listed as a choice. If this is selected, the
programmed variation function of the preset will be ignored by the
soundboard.
CC DEFAULTS…
Controller defaults…
In using the various possibilities of control you have using modulation
wheels , it is necessary for the controller value to be reset to its default
value (usually zero) after a preset change for example. But there are
exceptions. The soundboard expects a standard value of 64 for Controllers
71-74 because these controllers are used as offsets. Because there are
numerous non-standard Controllers available in the MIDI Protocol, that
manufacturers can use at will, your ZETA SYNTHONY II is equipped
with the ability to determine and set the default value for all these
controllers. Press the ENTER button to get to the submenu. In the first line
of the display shows the name and number of the presently selected
controller and in the second line, its default value in hexadecimal format.