Filter
Top Products
45 En
PREPARATION
CONNECTION/
INITIAL SETTINGS PLAYBACK SETTINGS
TROUBLESHOOTING
APPENDIX
Advanced setup
1
Press key to turn this unit to
standby mode.
2
While holding down INPUT key on the front
panel, press key on the remote
control to turn on the power.
“ADVANCED SETUP” appears in the front panel
display.
3
Release INPUT key on the front panel.
4
Press U/ V to select the desired
menu on the front panel display and then
press ENTER key.
1)
5
Change setting by pressing Y/Z key.
2)
6
Press key to set this unit to the
standby mode.
The new setting will be reflected when you turn on the
unit by pressing key.
Menu Description Selectable item/Adjustable range
TURN ON VOLUME Sets volume level at power-on. Off* (Not set), 01 to 99, MAX (Maximum)
MAX VOLUME SET Sets maximum volume. 01 to 99, MAX* (Maximum)
PANEL INP. KEY Enables/disables the INPUT key on the front panel. P.INPUT: ON* (Enabled), P.INPUT:OFF (Disabled)
F.PANEL. KEY Enables/disables the keys on the front panel. P.INPUT: ON* (Enabled), P.INPUT:OFF (Disabled)
R.INPUT POWER Enables/disables power-on by remote control input
keys when the unit is in standby mode.
R.INPUT PW: OFF* (Disables power-on),
R.INPUT PW: ON (Enables power-on)
AC ON STANDBY Sets whether or not this unit returns to its previous
state when AC power is restored after a temporary
power loss.
AC STANDBY: OFF* (Restores the state before
power was lost),
AC STANDBY: ON (Enters standby mode)
MEMORY PROTECT Prohibits saving of the settings by using the memory
setting function (☞p. 22).
PROTECT:OFF* (Protect is not performed),
PROTECT:ON (Protect is performed)
DEMO MODE Demonstrates sound beam.
3)
BEAM DEMO:OFF* (Normal playback),
BEAM DEMO:ON (Demo mode)
FACTORY PRESET Resets all settings to their default values. PRST:CANCEL* (Reset is not performed),
PRST: RESET (Reset is performed)
To return to the previous menu, press RETURN key.
The default settings are marked with “*”.
This unit outputs sound beam down-mixed to 1 channel moving
horizontally to right and left. By this function, you can feel how sound
beam is output from this unit.
“Demo” appears in the front panel display while setting demo mode.
Start/stop moving horizontally
Press Off key.
Auto Demo On: Sound beam automatically moves horizontally to right
and left
Auto Demo Off: The direction of sound beam is fixed
Adjust the angle of sound beam manually
Press SURROUND/ STEREO key in the state of “Auto Demo
Off”
1) y
2) y
3) y