Filter
Top Products
39 En
Setup menu
PREPARATION
CONNECTION/
INITIAL SETTINGS PLAYBACK SETTINGS
TROUBLESHOOTING
APPENDIX
MANUAL SETUP BEAM ADJUSTMENT
Use to manually adjust the various sound beam settings.
4)
Beam adjustment
1
Configure “HORIZONTAL ANGLE”.
Adjust the horizontal angle of sound beams for each
channel using test tones.
Adjust toward L (left) to move the direction of the output
to the left and adjust toward R (right) to move it to the
right.
Control range: L90° to R90°
2
Configure “BEAM TRAVEL LENGTH”.
5)
Adjust the distance that sound beams travel after being
output and reflected off the wall until they arrive at the
listening position so that all sounds can arrive at the
listening position at the same time.
Control range: 0.3 m to 24.0 m (1.0 ft to 80.0 ft)
The length of each arrow
indicates the beam travel
length.
( – ) ( + )
( + ) ( – )
3
Configure “FOCAL LENGTH”.
6)
Adjust the distance from the front of this unit to the focal
point of output for each channel to achieve an expansive
feeling for each channel. Adjust toward - (minus) to move
the focus outward (widen the sweet spot) and adjust
toward + (plus) to move the focus toward the normal
position (narrow the sweet spot).
We recommend that you use the initial setting
(-0.5 m or -1.5 ft) for “Center”.
Sub menu: Front L, Front R, Surround L, Surround
R
Control range: -1.0 m to +13.0 m (-3.5 ft to +43.5 ft)
Sub menu: Center
Control range: -1.0 m to -0.5 m* to +13.0 m (-3.5 ft
to -1.5 ft* to +43.5 ft)
Focal
length
Focal
point
Sweet
spot
Front left channel Center channel
Example
• The “BEAM ADJUSTMENT” parameters are automatically adjusted
(except “Center” in “FOCAL LENGTH”) if you run the AUTO
SETUP (☞p. 18) or if you configure “SETTING PARAMETERS”
(☞p. 38).
• Depending on the surround mode settings (☞p. 29), some channel
positions may not be available for selection. In this case, “- -” is
displayed.
Configure this setting only when you have adjusted “HORIZONTAL
ANGLE”.
The width of the sweet spot becomes slightly wider than the width of this
unit if you run the AUTO SETUP (☞p. 18) or if you configure
“SETTING PARAMETERS” (☞p. 38).
4) y 5) Note
6)
y