Filter
Top Products
Initial settings
22 En
You can save the current beam and sound settings in the system
memory of this unit. It is handy to save certain settings according
to the varying conditions of your listening environment. For
example, if there are curtains in the path of sound beams, the
effectiveness of the sound beams will vary depending on whether
the curtains are open or closed.
■ Saving settings
Saving several measurement results
(Memory setting function)
1
Press SETUP key.
2
Select “MEMORY” and press ENTER
key.
3
Press U / V key to select “SAVE”
and then press ENTER key.
4
Press U / V key to select the desired
memory number and then press ENTER
key.
1)
Selectable item: Memory 1, Memory 2, Memory 3
“Memory 1 Save Now ?” is displayed when the memory
number is selected.
5
Press ENTER key.
“Memory 1 Saving…” is displayed and the setting is
saved.
If there are curtains in your listening room, we recommend
following the procedure below.
1. While the curtains are open, run “BEAM+SOUND
OPTIMIZE” (☞p. 20) and then save the settings to
“Memory 1”.
2. While the curtains are closed, run “SOUND OPTIMIZE
ONLY” (☞p. 20) and then save the settings to
“Memory 2”.
• If system settings are already stored in the selected memory number,
this unit overwrites the old settings.
• Memory function cannot be set when “MEMORY PROTECT” is set
to “ON” in ADVANCED SETUP (☞p. 45).
1) y