Filter
Top Products
26 En
Troubleshooting
■ Remote control
Problem Cause Remedy
See
page
FM
FM stereo reception is
noisy.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
Check the antenna connections.
8
Try using a high-quality directional FM
antenna.
—
Use the manual tuning method.
19
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
There is multi-path interference. Adjust the antenna position to eliminate
multi-path interference.
—
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is too weak. Use a high-quality directional FM antenna.
—
Use the manual tuning method.
22
Previously preset
stations can no longer
be tuned into.
This unit has been disconnected for a
long period.
Set preset stations.
21
The Radio Data System
information does not
appear.
The Radio Data System information is
not provided by the radio station.
The signal is too weak Use a high-quality directional FM antenna
—
AM
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is weak or the antenna
connections are loose.
Tighten the AM loop antenna connections
and orient it for the best reception.
—
Use the manual tuning method.
19
There are continuous
crackling and hissing
noises.
Noise can result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
—
There are buzzing and
whining noises.
A TV set is being used nearby. Move this unit away from the TV set.
—
Problem Cause Remedy
See
page
The remote control does not
work nor function properly.
Wrong distance or angle. The remote control functions within a
maximum range of 6 m and no more than
30 degrees off-axis from the front panel.
3
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
Reposition this unit.
—
The batteries are weak. Replace all batteries.
3
Even if the remote control code is correctly
set, there are some models that do not
respond to the remote control.