Yamaha TX-761DAB Stereo System User Manual


 
8 En
Connections
Connect the supplied indoor DAB antenna to the DAB
antenna terminal on the rear panel and attach the indoor
DAB antenna vertically on the wall.
y
It is recommended that you use the tuning aid function (see
page 14) when you set up the indoor DAB antenna in order to
maximize DAB reception capability. After the automatic
scanning operation (see page 11), use “Signal Q” display to check
the signal quality of the currently received DAB service (see
page 18).
Be sure to check the DAB coverage in your area in that not all
areas are currently being covered. For a list of nationwide DAB
statuses and worldwide DAB frequencies, check WorldDAB
online at “http://www.worlddab.org/”.
If the DAB signal is weak, use a commercially available
outdoor DAB antenna for better reception.
Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
The AM loop antenna should be placed away from this unit.
A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
The wire of the AM loop antenna does not have any polarity.
Assembling the supplied AM loop
antenna
Connecting the wire of the AM loop
antenna
Connecting the DAB antenna
Notes
Connecting the FM and AM
antennas
Notes
DAB
ANTENNA AC IN
Indoor DAB antenna
(supplied)
FM GND AM
ANTENNA
AM loop
antenna
(supplied)
Ground
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
Indoor FM
antenna
(supplied)
Outdoor AM antenna
Use a 5 to 10 m of vinyl-
covered wire extended
outdoors from a window.
Press and hold
Insert
Release