Filter
Top Products
47
English
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
Once you set the appropriate manufacturer codes, you can
use this remote to control your other components. Note
that some buttons may not correctly operate the selected
component. Use the input selector buttons to select the
component you want to operate. The remote control
automatically switches to the appropriate control mode for
that component.
■ Default codes
The following table shows the default component
(Library: component category) and the manufacturer code
for each area.
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set another YAMAHA manufacturer code.
■ Setting a code
1 Hold down CODE SET while doing steps 2
and 3.
2 Press an input selector button to select the
source component you want to set up.
3 Press the numeric buttons to enter the three-
digit manufacturer code for the component
to be used, then release CODE SET.
Refer to “LIST OF MANUFACTURER CODES” at the
end of this manual.
y
To reset an input area’s manufacturer code to the factory default,
input the default code (see “Default codes” above) in step 3.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 10 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
• Replace the batteries frequently. The settings may be lost after
two minutes without power supply.
Setting manufacturer codes
Input area Manufacturer Code
TV (DTV/CBL) YAMAHA 299
VCR YAMAHA 399
DVD (DVD/CD) YAMAHA 699
Note
CODE SET
VCRDVD/CD VIDEO 1
TUNERDTV/CBL VIDEO 2
Notes
1
HALL
2
JAZZ
3
ROCK
4
ENTERTAIN
5
MUSIC
6
TV THTR
7
MOVIE 1
8
MOVIE 2
9
q
/DTS
0
NIGHT
+10
EX/ES
ENT
STEREO
EFFECT
01EN.00_RX-SL100RDS.book Page 47 Thursday, November 27, 2003 12:42 PM