Filter
Top Products
36
ADVANCED OPERATIONS
■ Displaying information about the input
source
You can display the type, format and sampling frequency
of the current input signal.
1 Press AMP.
2 Press STEREO/EFFECT so that “STEREO”
appears in the display.
3 Press k/n to display the following
information about the input signal.
(Format) Signal format display. When the unit
cannot detect a digital signal it
automatically switches to analog input.
in Number of source channels in the input
signal. For example, a multi-channel
soundtrack with 3 front channels, 2
surround channels and LFE, is
displayed as “3/2/LFE”.
fs Sampling frequency. When the unit is
unable to detect the sampling
frequency “Unknown” appears.
rate Bit rate. When the unit is unable to
detect the bit rate “Unknown” appears.
flg Flag data encoded with DTS or Dolby
Digital signals that cue this unit to
automatically switch decoders.
You can adjust the output level of each speaker while
listening to a music source. Please note that this operation
will override the level adjustments made in the Speaker
Level section of BASIC setup (see page 17) and “Using
the test tone” (page 37).
1 Press AMP to select the AMP mode.
2 Press LEVEL repeatedly to select the
speaker you want to adjust.
FRONT L Front left speaker level
CENTER SP Center speaker level
FRONT R Front right speaker level
SUR.R Surround right speaker level
SUR.B Surround back speaker level
SUR.L Surround left speaker level
SWFR Subwoofer level
y
Once you press LEVEL, you can also select the speaker by
pressing k/n on the remote control.
3 Press l / h to adjust the speaker output
level.
• The control range is from +10 dB to –10 dB.
When inputting digital signals with sampling frequencies higher
than 48 kHz, only the subwoofer level can be adjusted.
ENT
STEREO
EFFECT
ENTER
Manually adjusting speaker levels
Note
AMP
TITLE
LEVEL
ENTER
01EN.00_RX-SL100RDS.book Page 36 Thursday, November 27, 2003 12:42 PM