Filter
Top Products
8
Basic use
– using a preset program –
ProR3 Digital Reverberator
Adjusting the input level
When the power has been turned on for the ProR3 and the other equipment, make the sound
sources produce sound, and adjust the input level of the ProR3.
1. Rotate the INPUT level controls while watching the INPUT level meters.
Set the levels to achieve maximum S/N ratio while not allowing the CLIP indicators to light.
Selecting effect programs
There are two ways to select programs.
• Use the INC/DEC keys.
Press the INC or DEC key to select a program.
If you hold down a key, the program numbers will change in succession.
• Use the numeric keys and the RECALL/ENTER key.
1
Use the numeric keys to select the program number, and the PROGRAM indicator will
blink.
If you enter the wrong number, press the CANCEL key, and use the numeric keys to enter
the number once again.
If you select a number other than 1–90, the display will indicate “
**
NO PRO-
GRAM
**
No Type”. Press the CANCEL key to return to the previous display.
2
Press the RECALL/ENTER key to recall the program.
When the program is recalled, the PROGRAM indicator will change from blinking to lit.
If you select a number other than 1–90 and press the RECALL/ENTER key, the display
will indicate “
*
Program Number Error
*
”. Press the CANCEL key to return to the previ-
ous display.
Note:
If the display asks “Recall? Are you sure?” when you select a program, this indicates that the
data of the program has been edited. If you wish to save this edited data, use the procedure “Saving a
program” given on page 16.
If you do not need to save the edited data, press the RECALL/ENTER key to recall the selected program.