Filter
Top Products
6
Rear panel
ProR3 Digital Reverberator
Rear panel
15 MIDI connectors
These are 5 pin DIN type standard MIDI IN, MIDI OUT, and MIDI THRU connectors.
These connectors are used when transmitting program change messages or control change mes-
sages from an external MIDI device to the ProR3, or when transmitting program bulk dump data
from the ProR3 to another device.
16 OUTPUT jacks
These are balanced output jacks which output the analog return signal to your mixer or multi-
track recorder, etc. A pair of XLR-3-32 connectors and a pair of 1/4" phone jacks are provided.
The level select switch selects either +4 dB or –10 dB as the nominal output level.
17 INPUT jacks
These are balanced input jacks which input the analog signal from your mixer or multi-track
recorder to the ProR3. If the source is monaural, use the UTILITY key to select an appropriate
input jack (see page 33).
A pair of XLR-3-31 connectors and a pair of 1/4" phone jacks are provided.
The level select switch selects either +4 dB or –10 dB as the nominal input level.
18 Level select switches
These switches change the level of the input/output jacks between +4 dB and –10 dB.
Set them to match the level of the connected equipment.
RL
RL
LR
LR
MIDI OUTPUT
INPUT
–10dB +4dB –10dB +4dB
THRU OUT IN
H
GEF
XLR3-31 type pin arrangement
1/4" phone plug signal connections
XLR3-32 type pin arrangement
2
1
3
Cold
Hot
Ground
(Earth)
1
2
3
Hot
Cold
Ground
(Earth)
Ground
Hot
Cold