XM Satellite Radio R-672 Stereo Receiver User Manual


 
9
XM Mini-Tuner system
• To emphasize the deep bass sounds, connect a powered
subwoofer.
Note :
• When the power amplifier is assigned to "SB+W" (Surround
Back+Subwoofer), no signals are output from the
SUBWOOFER PRE OUT jack. (For details, refer to "When
selecting the AMP ASSIGN" on page 37.)
6. CONNECTING SUBWOOFER PRE OUT
• Connect the XM terminal to the XM Mini-Tuner system (sold
separately).
• Position the XM Mini-Tuner system near a south-facing
window to receive the best signal.
When making connections, also refer to the operating
instructions of the XM Mini-Tuner system.
• For the best reception, check the signal strength of the XM radio
signal with using signal strength display mode, then adjust the
position of the XM Mini-Tuner system until “GOOD” is displayed.
(For details, refer to “Displaying XM information” on page 30.)
• To listen to XM Satellite Radio, refer to “XM Satellite Radio
(only for North America)” on page 28.
7. CONNECTING XM (only for North America)
• Be sure to connect speakers firmly and correctly according to
the channel (left and right) and the polarity (+ and -). If the
connections are faulty, no sound will be heard from the
speakers, and if the polarity of the speaker connection is
incorrect, the sound will be unnatural and lack bass.
• For installing the speakers, refer to "Speaker placement" on
page 10.
• After installing the speakers, first adjust the speaker settings
according to your environment and speaker layout. (For details,
refer to "SETTING THE SPEAKER SETUP" on page 41.)
Surround back speakers
• When using only one surround back speaker, you should
connect it to SURROUND BACK LEFT channel.
In this case, you can connect a subwoofer without built-in
amplifier to the SURROUND BACK RIGHT channel. (For details,
refer to “When selecting the AMP ASSIGN” on page 37.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms or
above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or the
speakers.
8. CONNECTING SPEAKERS
ENGLISH