Filter
Top Products
23
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR SR
Front Left Center Front Right Surround Right
SW SL ( SB) or ( BL BR)
Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right
• When the speaker setting is "N” (None or No), the test
tone of the corresponding channel is not available.
• ( ) : Possible depending on whether the surround back
channel is set to "2c" (2ch) or "1c" (1ch).
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the SPEAKER button is set to off or it is in the stereo mode, etc., the test tone function does not work.
Adjusting each channel level with test tone
Continued
When selecting the “WIDE” (Dolby Virtual Speaker Wide) mode
2 SP : When using 2 front speakers only.
3 SP : When using 2 front and center speakers
4 SP : When using 2 front and 2 surround speakers.
5 SP : When using 2 front, center and 2 surround speakers.
Note: When the speakers are set to “N” (None), the corresponding speaker layouts cannot be selected.
[Dolby Headphone Parameters]
When selecting the “DH 1”, “DH 2”, “DH 3” (Dolby Headphone 1,2,3) mode
MOVIE : This provides the surround effect suitable for movie sources.
MSC 1 : This provides the surround effect suitable for music sources.
MSC 2 : This provides less surround effect compared to Music 1 mode.
Note : You can select the listening mode only when playing analog stereo, PCM 2 channel or Dolby Digital 2 channel source.
4. Repeat the above steps 2 and 3 to adjust other parameters
1. Enter the test tone mode. 2. At each channel, adjust the level as desired until the
sound level of each speaker is heard to be equally loud.
3. Cancel the test tone function.
• You can select the desired channel with pressing the
CONTROL UP(
)/DOWN( ) buttons or the CURSOR
UP(
)/DOWN( ) buttons.
ENGLISH