Filter
Top Products
ENGLISH
46
Continued
1. Press the CURSOR UP( )/DOWN( ) buttons to select the “X-OVER”, then press the ENTER button.
2. Press the CURSOR UP( )/DOWN( ) buttons to select the desired speaker.
3. Press the CURSOR LEFT( )/RIGHT( ) buttons to set the crossover frequency as desired.
4. Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.
• You can adjust the crossover frequency within the range
of 40 ~ 200 Hz in 10 Hz intervals.
When selecting the SPEAKER CROSSOVER
• Each time CURSOR UP( )/DOWN( ) buttons are
pressed, “F” (Front), “C” (Center), “S” (Surround) or “SB”
(Surround Back) is selected.
Note :
• You cannot select the subwoofer and the speakers set to
"N" (None).
About the crossover frequency
• When speakers are set to "S" (Small), low frequencies in those channels that are below the crossover frequency are to output
from subwoofer or front speakers which are set to “L” (Large) (when not using a subwoofer).
• Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100 Hz~20 kHz,
the crossover frequency should be set to 100 Hz(or slightly higher).
• When speakers are set to "S" (Small), be sure to set their crossover frequency correctly according to their frequency
characteristics.