Filter
Top Products
68
Function setup (DVD)
Customizing the function settings (Continued)
DRC : Off
QSound : On
Menu : English
Subtitle : English
Audio : English
E.B.L. : Off
TV Screen : 4:3
Display : On
Picture Mode : Auto
JPEG Interval : 5 Seconds
Screen Saver : On
Parental : Off
Password : Change
HD Jpeg : Off
Output : Interlace
DivX(R) VOD : Display
Parental control setting
Some discs are specified not suitable for children.
Such discs can be limited not to play back with the
unit.
1) Press C or D to select “Parental”, then press
ENTER. “Enter Password” screen will appear.
2) Press “0000” using Number buttons (0–9).
(Please note, this is pre-setting password of this
unit). Then press ENTER. The parental level list will
appear.
• Level Off: The parental control setting does not
function.
• Level 8:Virtually all DVD software can be
played back.
• Level 1: DVD software for adults cannot be
played back.
3) Press C or D to select from the level 1 to level 8.
The limitation will be more severe as the level
number is lower. Then press ENTER.
4) Press OPEN/CLOSE to activate Parental control
setting.
Notes:
• Depending on the discs, the unit cannot limit
playback.
• Some discs may not be encoded with specific rating
level information though its disc jacket says “adult.” For
those discs, the age restriction will not work.
• The password is required every time when you change
the parental level.
• If you input a wrong number, press CLEAR.
Set the new password
1) Press C or D to select “Password”, then press
ENTER. “Enter Current Password” screen will
appear.
2) Press Number buttons (0–9) to input the current
password (If the password has not been set yet
after you purchase this unit, it is “0000”).
3) Then press ENTER. “Enter New Password” screen
will appear. Press Number buttons (0–9) to input
the new password.
4) Press ENTER. Now your new password has been
set. Be sure to remember this number!
If you forget the password...
1) Press OPEN/CLOSE to open the disc tray.
2) Remove the disc.
3) Press OPEN/CLOSE again to close the disc tray.
“No Disc” appears on the screen.
4) While holding 7 down on the remote control and
at the same time press STOP on the front panel.
“Password Clear” appears on the screen. Now the
password has been returned to the initial value
(“0000”).
HD Jpeg
This DVD/VCR equipped with a “HD Jpeg”. It can display
the HD resolution JPEG images when the DVD/VCR is
connected to a HDTV using HDMI.
On:
Select when you connect the DVD video player to
a HDTV via HDMI OUT jack. JPEG images is dis-
played in suitable picture quality (480p, 720p or
1080i)
.
Off:
The picture processing quality is fixed to 480p.
Notes:
• When the DVD/VCR is not connected to a TV using
HDMI, you cannot select “On”.
• When HD Jpeg is set to “On”, zoom function is prohibited
and component video outputs disabled when 480p, 720p
or 1080i is selected.
Setting details
2I40301A-En_p60-69 21/3/06, 9:46 AM68