Filter
Top Products
42
Recording (VCR)
Timer recording
Timer recording can be programmed on-screen with the remote control.
The built-in timer allows automatic unattended recording of up to 8
programs within 1 month.
Timer recording
Notes:
• Press CANCEL to move cursor backward for correction.
• To record from external source set the channel to “L1” or
“L2”.
Notes:
• If the timer symbol ( ) blinks when the timer recording ended,
the TV program has not been completely recorded because of
an insufficient tape length. Press TIMER REC to cancel the
timer program or press EJECT to remove the cassette tape.
• During timer recording standby mode, the VCR mode cannot be
operated. To use the VCR, first press TIMER REC then press
DVD/VCR SELECT to change to VCR mode. After VCR mode
is selected, press TIMER REC again to put the VCR into timer
recording standby mode.
• If you press TIMER REC during timer recording, the recording
operation will be interrupted. If you press TIMER REC again
within the programmed time, the recording operation will start
again.
• After a power failure or disconnection of the power plug, all
programmed recording settings and time display will be lost
upon resumption of power. In this case, reset the clock and
reprogram any timer recording.
Press VCR MENU. Select “TIMER REC SET”,
then press ENTER.
Preparation:
• Press DVD/VCR to operate the DVD/VCR.
• Press DVD/VCR SELECT to select the VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Check the time and date are correct
.
Example: Program a timer recording for the 26th day,
channel 125 (Cable TV), 11:00 - 11:30 PM on timer
program number 1 (Tape speed: SLP).
1
Press SET + or – to select one of the program
line, then press ENTER.
2
Press SET + or – to select the date, then press
ENTER.
3
Set the start time, end time, channel and tape
speed as in step 3.
4
To enter other programs, repeat steps 2
through 4.
• To return to the normal screen,
press VCR MENU twice.
5
Press TIMER REC. The timer symbol ( ) will
appear on the display and the VCR standbys
for recording.
At the same time, VCR mode will
change to DVD mode automatically.
You can use DVD even if the VCR is
in the timer recording mode.
If you do not use the DVD, turn the
power off.
6
Notes:
• The timer recording will start at 5 seconds before the
preset starting time.
• If the timer symbol ( ) does not appear on the display
when TIMER REC is pressed, the cassette is not inserted
34
.
• If the cassette is ejected when TIMER REC is pressed, the
erase prevention tab of the cassette may have been
removed
34
.
• During Timer recording, the power cannot be turned off.
SET +/–
DVD/VCR
ENTER
CANCEL
VCR MENU
EJECT
TIMER REC
DVD/VCR SELECT
〈 〉
〈 〉
〈 〉
〈 〉
2I40301A-En_p40-43 21/3/06, 9:44 AM42