Filter
Top Products
5.2. Track Sequence Selection [BA-800, BA-806 and BA-823]
When both cassette player units (TAPE 1 and 2) are used, the tapes can be played back in order of side A-A-B-B
or A-B-A-B, which is selectable by means of the track sequence selection switch.
(1) Alternate A-A-B-B Playback
With the track sequence switch set to A-A-B-B position, both cassette player units first play back side A of their
respective tapes, and then side B, starting with TAPE 1. This is repeated between both cassette player units in the
following sequence:
(2) Alternate A-B-A-B Playback
If the track sequence selection switch is set to A-B-A-B position, both cassette player units alternately play back
both sides (A and B) of their respective tapes before they are switched to each other.
[Note]: (1) Side A of the tape mentioned above refers to the side to play first. Therefore, it is not the same as
that which is shown on the tape.
(2) Be sure to set the link switch to OFF when using a BA-800 (BA-806 or BA-823) individually.
If set to ON, the tape stops after TAPE 2 playback is finished.
START
Side A of TAPE 1
Side B of TAPE 1
Side A of TAPE 2
Side B of TAPE 2
— 20 —