Filter
Top Products
(3) Tape Ejection and Loading
Press the eject button
to eject the tape. When inserting a new tape, set the Dolby NR switch to ON or OFF
depending on whether or not the tape has been recorded using the Dolby NR.
[Note]: ( 1 ) Tape can be ejected only when the power is ON. (It cannot be ejected if power is OFF.)
(2) When both cassette player units (TAPE 1 and 2) are loaded with tapes, if the tape being played back
is ejected, other tape is played back.
TAPE 1 ejected.
TAPE 2 ejected.
TAPE 2 played back
TAPE 1 played back
( 3) Do not block tape actions when ejected, because this may result in equipment failures or cause the
fault indication facility to malfunction.
(4 ) When ejecting and instantly re-loading the tape, wait until the tape is completely ejected. Your
attempt to force the tape in the cassette player unit while it is still being ejected may lead to
equipment failures or malfunctions of the fault indication facility.
(5) When the fault indication facility malfunctions, it can be returned to normal by pressing the eject
button.
(4) Timer ON/OFF Control
Confirm that the program timer is connected properly, as indicated on p.16.
Set the power switch to ON, and confirm that the power indicator lights.
Insert a tape.
Play begins when the player's timer ON terminals are shorted by the timer.
Play stops when the player's timer OFF terminals are shorted by the timer.
[Note]: ( 1) The timer ON/OFF control can be performed only when the power is ON. Be sure to set the power
switch to ON before inserting the tape.
(2 ) Adjust the tape volume to an appropriate level in advance. (BA-806/BA-823)
When using a timer to activate the BA-800, adjust the monaural line output volume control to an
appropriate level in advance.
(5) AGC Circuit [BA-800, BA-806 and BA-823]
Your tape player has a built-in AGC (Automatic Gain Control) circuit to maintain the tape output volume constant
regardless of variations in the recording level of each tape. This eliminates the necessity of adjusting the volume
control every time tapes are swapped.
To use the AGC circuit, set the AGC switch to ON. Set the switch to OFF if the function is not required.
— 18 —