Filter
Top Products
– 16 –
MAGNET ASSY ALIGMENT
1. Check that there is no disc in the unit and then turn ON the power. Open the door, and set a disc in the PLUS ONE slit.
2. Turn OFF the power, close the door, and while pressing the [CLEAR] and [PLUSONE] buttons simultaneously, turn ON the power
again.
3. Press the
[CHECK] button, and set the loading mode.
4. Press the ± button and chuck the disc.
5. Adjust the magnet assembly and magnet holder so that A=B as shown in the figure.
DISC HOLDER A ALIGMENT
1. Check that there is no disc in the unit and then turn ON the power. Open the door, and set a disc in the PLUS ONE slit.
2. Turn OFF the power, close the door, and while pressing the [CLEAR] and [PLUSONE] buttons simultaneously, turn ON the power
again.
3. Press the
[CHECK] button, and set the loading mode.
4. Press the ± button and chuck the disc.
5. Press ≠ or ± button to stop the disc holder A slightly away from the disc.
6. Rotate and adjust the adjusting screw so that the center of the disc and that of the disc holder coincide.
Magnet ASSY
Magnet ASSY
Magnet holder
Screw (For adjustment
)
A B
Disc
Disc
Disc holder A
Disc holder A
a b
a = b
Screw (For adjustment
)