Filter
Top Products
Triggering
3-118
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
Use the procedure that follows when setting up the instrument to trigger on a
sequence. For more information, display online help while performing the
procedure.
Overview To trigger on a sequence Control elements and resources
Prerequisites 1. The instrument must be installed with a signal
connected to an i nput channel. Acquisition system
should be set to Run, and the vertical and horizontal
controls should be set appropriately for the signal to be
acquired.
See page 3--26 for acquisition setup
To trigger on
a (main) only
1. From the toolbar, touch Trig and select the A-->B Seq
tab of the Trigger control window.
2. Touch A Only to turn off sequential triggering.
To Trigger on a Sequence