TechniSat DigitMod T1 Stereo Receiver User Manual


 
6.2.2 Country
This function provides for automatic adjustment for summer
and winter time. Using the arrow keys right/left, enter
your home country in the line Country.
> Press the Back key to return to the menu Settings,
or press the Menu key to return to normal operation.
The settings are automatically stored in memory.
6.2.3 Remote control code
Your digital receiver can be operated wither with the remote
control unit supplied (remote control code Sat2), or with an
optional remote control unit utilising remote control code Sat1.
This option allows you, for instance, to operate two similar
sets in the same room, with each being controlled independ-
ently, and without interference of the other. To do this, unit 1
is controlled by remote control code Sat1, and unit 2 by remo-
te control code Sat2.
In this line, decide whether your receiver should be allocated
the remote control code SAT1 or SAT2.
> In this line, operate any key of the appropriate remote
control unit (Sat1 or Sat2) to select the remote control
code.
> Press Back to return to the menu Settings, or press
Menu to return to normal operation. The settings will
be stored automatically.
6.2.4 Antenna feed 5V
If you are using an active antenna, you will have to switch on
the antenna power feed (5V/30mA). The antenna will be fed
via the terrestrial antenna input.
> In this line, use the arrow keys left/right to switch
the antenna feed on or off.
In case of an overload or short circuit of the antenna feed,
this will be switched off automatically. If this occurs, rectify the
problem/cause, then switch the antenna feed on again.
6.2.5 Stand-by clock*
To reduce the power consumption of your unit in -standby
mode, you have the option of switching the clock time display
on or off.
> In this line, use the arrow keys left/right to set the
standby clock mode to on or off.
> Press Back to return to the menu Settings, or press
Menu to return to normal operation. The settings will
be stored automatically.
16
*valid only for DigiPal 2
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 16