TechniSat DigitMod T1 Stereo Receiver User Manual


 
4 Connections
The references below to items a b c etc. refer to the illustra-
tion on page 10.
4.1 Antenna
a The cable coming from the terrestrial antenna (roof-
mounted or room antenna) should be connected with
the terrestrial antenna input of the receiver.
Wherever possible please use a roof-mounted anten-
na. An internal room antenna may be sufficient under
very favourable reception conditions. If an active
antenna is being used, ensure that the antenna feed
is switched on (Point 6.2.4).
4.2 Connection to a television set
4.2.1 Using a SCART cable
b Connect your receiver (SCART socket TV) and the
television set (SCART socket) by means of a SCART
cable. If your television set is appropriately equipped,
this will switch automatically to AV mode when the
digital receiver is switched on, and will thus switch to
DVB-T operation.
4.2.2 Using HF cable
If you wish to continue receiving any analogue programmes
that may be available, the digital receiver must be connected
to the antenna input of the television set.
c Connect the receiver (antenna output) with the
antenna input socket of the television set, using a sui-
table cable connection.
4.3 Video cassette recorder (VCR)*
d Connect the video recorder to the SCART socket
VCR. In playback mode, the video recorder will sup-
ply a switching signal to the digital receiver. The video
recorder signal will be supplied automatically to the
televison set.
If your video recorder does not supply a switching sig-
nal, use the O/AV key to switch your digital receiver
to the external input AV. Press this key again to revert
to normal operation.
11
*valid only for DigiPal 2
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 11