Technics SA-DA10 Stereo Receiver User Manual


 
5
RQT5518
To enjoy surround sound
30° 30°
120°
30° 30°
120°
Before use
Do the connections, settings, and adjustments in the order shown to enjoy surround sound.
Be sure to make the correct speaker settings. If, for example, you have not connected a center speaker and you leave the initial setting value
of LARGE as it is, then dialog and other sounds may not be reproduced.
Connect the equipment
(a Pages 10–13.)
Position and connect the
speakers
(a Pages 14–16.)
Sit back and enjoy the
experience
(a Pages 22–23.)
Adjust the level for the
speakers
(a Page 19.)
Set the presence and type
(small/large), distance and
filter of the speakers you
have connected
(a Pages 17–18.)
In SIZE
Select LARGE or SMALL for the front speakers
Select LARGE, SMALL, or NONE for the center and
surround speakers
Select YES or NO for the subwoofer
In DISTANCE
Enter the distance of the front, center, and surround
speakers from the listening position
In FILTER
Enter the cutoff frequency for your subwoofer based on
the bass capability of your front speakers
Front speaker
(left)
(not included)
Center speaker
(not included)
Front speaker
(right)
(not included)
Surround speaker
(left)
(not included)
Surround speaker
(right)
(not included)
Subwoofer
(not included)
The front, center, and surround speakers should be placed
at approximately the same distance from the listening
position. The angles in the diagram are approximate.
While sitting in the usual listening position, use the test
signal to adjust the volume of the speakers to the same
apparent level.
When using DVD 6CH INPUT mode
These settings need to be changed on the player.
Read the player’s instructions for setting details.