Filter
Top Products
17
RQT5518
1
2
3
12
3
-1
3
-2
3
-3
SPEAKERS
AB
SPEAKERS
AB
SPEAKERS
AB
INPUT SELECTOR
2
1
3
Speaker settings
These settings should be done to get the most from the unit’s DSP
reproduction modes (a pages 20 and 21).
In SIZE
Set the type (LARGE or SMALL) and presence (NONE, YES or
NO) of your speakers. Select “LARGE” if the speakers can
produce bass (below around 100 Hz). Select “SMALL” if the
speakers cannot produce bass. Select “NONE” if center and
surround speakers aren’t connected. Select “NO” if a subwoofer
isn’t connected. The sound for those speakers is then produced
through the front speakers.
In DISTANCE
Enter the distance of front, center surround speakers from the
listening position so the sound from the speakers reaches the
listening position at the same time. The unit calculates the delay
time for the center and surround speakers based on these
distances.
In FILTER
Enter the cutoff frequency for your subwoofer based on the bass
capability of your front speakers
1 Press [ /l].
2 Press [A] and [B] at the same time.
“SETTING” appears on the display.
3
To set “SIZE”
11
11
1 Press [A] to select “SIZE”.
Each time you press the button, the display switches as
follows.
SIZE DISTANCE FILTER DR COMP
22
22
2 Press [B] to select the speaker
channel to be set.
Each time you press the button, the display switches as
follows.
FRONT CENTER SURROUND SUB-WFR
SUB-WFR=SUBWOOFER
33
33
3 Turn [INPUT SELECTOR] to set the
type (LARGE, SMALL) and
presence (NONE, YES or NO) of the
speaker.
Each time you turn the selector, the display switches as
follows.
FRONT:
SMALL LARGE
CENTER, SURROUND:
NONE SMALL LARGE
SUBWOOFER:
NO YES
The factory settings are as follows.
Front, center and surround speakers: LARGE
Subwoofer: YES
44
44
4 Repeat steps
22
22
2 and
3 3
3 3
3 to
complete the size settings for all
speakers.
(Continued on next page)
Preparatory steps
Connection, Preparation