Filter
Top Products
RQT5518
46
To change the remote control code
Hold down the button corresponding to the
component you wish to operate.
Continue to hold the button down and...
Aim the remote control at the component you wish
to operate and carefully and slowly press the
numbered buttons to enter the appropriate two-
digit code number.
(Refer to the tables on the facing page for the code numbers.)
When the two-digit code number is entered, the remote control will
automatically output the on/off signal.
If you changed the code correctly, the component switches on or off.
Change the remote control code in either of the following
circumstances:
¡If the Panasonic TV, VCR or DVD player does not operate as a
result of a difference in the remote control code.
¡If you wish to operate some other make of TV, VCR or DVD
player.
(a Refer to pages 42–45 for the buttons which can be used.)
Note
¡Even after changing the code there may be cases where certain
operations cannot be done or operation is not possible at all.
¡Changes to the codes are canceled when the remote control’s
batteries are replaced. Reenter the code.
SA-DA10 only
The remote control
+
–
1
4
7
0 -/--
89
56
23
TV VCR
TAPE CD
TUNER/BAND
DVD
CH
DIRECT TUNING/
DISC ENTER
VOLUME
MUTING
≥10/ENTER
DISC/DECK 1/2
MD
SOUND MODE
SFC
SLOW/
SEARCH
DELAY
TOP MENU
ENTER
MENU
DISPLAY RETURN
SUB TITLE
AUDIO ANGLE
+
–
LEVEL
TEST
GROUP
–+
DIMMER
DVD 6CH
PAGE
TV VOL TV/AV
DVD
–+
TV
1
4
7
0
89
56
23
1
4
7
0
89
56
23
VCR DVD