Technics SA-DA10 Stereo Receiver User Manual


 
RQT5518
28
2
1
3
Selected band
132
VGCAFM MODE, EON
INPUT SELECTOR
BAND
TUNING
PTY SELECTOR
MHz
TUNED STEREO
SPEAKERS
MHz
A
Use the tuning buttons to tune-in radio stations.
1 Turn [INPUT SELECTOR] to select
“TUNER”.
2 Press [BAND] to select “FM” or “AM”.
3 Press [TUNING , , , PTY
SELECTOR] (for the United Kingdom)
or [TUNING , , ] (for Australia and
New Zealand) to tune to the desired
frequency.
“TUNED” lights up when tuned.
“STEREO” lights up when an FM stereo broadcast is
received.
To make an automatic search for stations
Hold down [TUNING, , , PTY SELECTOR] (for the
United Kingdom) or [TUNING, , ] (for Australia and
New Zealand) until the frequency begins to scroll. Tuning
stops when a station is found. (Tuning may stop if there is
interference.)
If noise is excessive in the FM stereo mode
Press [FM MODE, EON] (for the United Kingdom) or [FM MODE]
(for Australia and New Zealand).
(“STEREO” will go out, and “MONO” will light up).
The broadcast will be monaural, but noise will be reduced.
If the button is pressed once more, the stereo mode resumes.
If there is hissing or thumping while the radio is
playing
Turn VGCA on.
This turns DSP off and can improve sound.
(\ Page 27 for details about VGCA.)
For your reference
The tuner can pick up interference from DVD players. If this
occurs turn the DVD player off.
To change the AM frequency step
Press and hold [BAND] for about 3 seconds when AM band is
selected. (The frequency step changes from 9 kHz to 10 kHz.)
To return to the previous step, press and hold [BAND] for about 3
seconds again.
The radio
Sequential tuning