Filter
Top Products
39
RQT5518
To operate the receiver
To switch between on and standby
To select an input source (except PHONO and VCR 2/
FRT-VCR 3) and switch the remote control to each
operation mode
To turn SFC on and select the mode
To output a test signal
To select the speaker channel and adjust its output level
To mute the sound level
To adjust the volume
To select the DSP sound modes
When an SFC mode is on
To change the surround channel delay time
To select DVD 6CH INPUT mode
To dim the display
To select “FM” or AM”
To select the desired channel sequentially
(Preset tuning)
To select radio stations by frequency
(Direct tuning)
(Example: Channel 1) (Example: Channel 10)
within 10 seconds
To select the desired channel directly
(Preset tuning)
Remote control
Note
¡ TAPE MONITOR cannot be controlled with the [TAPE] button.
¡ The remote control for Australia and New Zealand does not have
an [MD] button.
¡When the SURROUND or SFC modes are on
(a Pages 19 and 23)
You can adjust the level of the center and surround speakers and
the subwoofer.
¡When the STEREO mode is on
You can adjust the level of the subwoofer.
1
0
≥10/ENTER
1-/--
(a Page 26)
(a Page 22)
(a Page 23)
(a Page 19)
(a Page 23)
(a Page 37)
(a Page 29)
(a Page 37)
(a Page 29)