36
Timer-Controlled Playback and Recording (2)
NOTE
If you have previously used the cassette, and the tape is stopped
part of the way through “side B” of the cassette, timer recording
will then start part of the way through “side A”. Always bear this
in mind, so that you do not accidentally erase any important
recordings. You should take special note of this when recording
more than once on the same cassette using the timer recording
function.
4
Set the CD-TAPE-USB switch to TAPE.
This unit cannot record to CDs and USB storage devices with the
timer recording.
5
Set the OFF-PLAY-REC switch to the REC position.
“TIMER” and appear on the AD-800’s display.
6
Tune in the station that you want to record (when
recording from radio).
7
Adjust the recording level.
Failure to do so could cause the recorded sound to be distorted
or noisy.
Use the REC LEVEL knob to adjust the recording level so that the
loudest sound does not continually exceed the “0” indicator on
the peak level meter.
8
Set the audio timer to your desired start (power on) and
stop (power off) times.
When this setting is completed, the power to all components
will be switched off.
At this time, do not press the AD-800 POWER button.
Leave the button pushed in (the on position). If the
POWER button is in the off position, timer recording will
not function.
When the preset start time is reached, power will be supplied
and recording will start automatically.
When you do not want to use the timer, be sure to set the OFF-
PLAY-REC switch to the OFF position to prevent accidentally
recording over an important cassette tape.