Filter
Top Products
DAW
In this section you route the outputs of your DAW.
DSP
The DSP outputs are: Main, AUX1, AUX 2 outputs and
Fabrik R sends. The AUX outputs are typically used for
headphones.
SSppeeaakkeerr SSeettss
Three speaker setups can be setup and switching between
the sets is easy. The speaker setups A, B and C can be
individually labeled according to your specific application.
8 Speaker or Line level ?
In the speaker section you select whether the signal is
routed to a speaker or directly to a line output at max
level. If this box is checked the level can be controlled
by the master level of the remote control. If not, line
is sent to outputs regardless of the master level
setting.
IIMMPPOORRTTAANNTT !!
If a source signal is NOT assigned to a speaker set,
you can check “DIRECT” and thus route the signal
directly to the mains out at
FFUULLLL VVOOLLUUMMEE..
If you e.g. have active monitors connected to the
outputs and these set at full volume, then sending
a signal, also at full volume, may damage the
speakers.
A pop-up dialog box will ask you to reconsider
before sending the un-attennuated signal to outputs.
9 Assigned to
Indicates which speaker set or sets the source is
assigned to.
19
SETUP PAGE