Filter
Top Products
56789101112
right right rightrightleftleftleftleft
ch2|right
input output
ch1|left
OUT
IN
mainstereooutputsMIDI
WCK
spdif opto
firewireremote
100-240VAC~ 50-60Hz, 25W
in in inout outout
tos
3-4
adat main
adat 96k
tos
1-2
SERIAL NO.
TC ELECTRONIC
DESIGNED AND
DEVELOPED BY
WARNING
TO REDUCE THE RISK OF FIREOR ELECTRIC
SHOCK DONOT EXPOSE THIS EQUIPMENTTO
RAIN OR MOISTURE
AVIS:
RISQUE DE CHOC ELECTRIQUE-NE PAS
OUVRIR.
CAUTION
R
CUS
RISK OF ELECTRIC SHOCK
DO NOT OPEN
UL60065
EN/IEC 60065
8
REAR PANEL
1 Power In
Mains power in. Studio Konnekt 48 uses a switch-
mode power-supply that accepts from 100 to 240VAC.
2 Word Clock In
If you want to sync to an external word clock
generator, connect it to WCK In using BNC connectors
and select “Word Clock” as sync source on the
System Settings page.
3 Word Clock Out
Due to the DICE II chip, Studio Konnekt 48 can act
as an excellent master clock generator for you setup.
Connect via standard BNC plugs.
Beware that the Word Clock signal is not
standardized. Some Word Clock receivers are
known to fail when the peak-to-peak signal
exceeds 3 Volt, and others are known to require at
least 4 Volt, making it impossible to design a
Word Clock driver guaranteed to operate with all
receivers. Studio Konnekt 48 sends 1.7V PP.
4 S/PDIF In/Out
Two channel, 24 bit 96 kHz digital in/out on S/PDIF.
In addition to standard I/O it is possible to insert e.g.
an external digital effects unit and use this as a send
effect. (see setup examples)
5 ADAT/Toslink I/O connectors
The optical connections carry either Toslink (optical
S/PDIF) or ADAT signal.
ADA
T:
- At normal sample rate, 8 channels of ADAT is carried
on a single lightpipe. Use the MAIN connector.
- At double sample rate, 8 channels of ADAT is
distributed on 2 lightpipe connectors. Use both the
MAIN and the 96 kHz connections.
T
oslink:
- Studio Konnekt 48 handles up to 4 input channels
and 4 output channels of optical S/PDIF via Toslink.
6 MIDI In/Out
Standard MIDI in/out. When Studio Konnekt 48 is
used in stand-alone mode, MIDI out always acts as
MIDI thru.
7 Main Outputs
Digitally controlled true analog main outputs on
balanced XLR.
Pin 1 Ground
Pin 2 Hot
Pin 3 Cold
8 In/Out - additional channels
Input and outputs for channels 5 to 12 on balanced
1/4” jacks. The sensitivity for the line inputs can be
set to -10 dBv or +4 dBu via the TC Near mixer page.