Filter
Top Products
1 – Introduction—Environmental considerations
8
TASCAM CD-RW2000
The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
NOTE
When transporting the unit, always use the original
packing materials. For this reason, we strongly rec-
ommend that you save all the packing materials that
came with the CD-RW2000, in case you need to
transport it in the future.
In addition, when transporting the unit, you should tape the
disc tray closed, using an adhesive tape that will not spoil
the finish of the unit.
1.4.1 Beware of condensation
If the unit (or a compact disc) is moved from a cold
to a warm place, or used after a sudden temperature
change, there is a danger of condensation; vapor in
the air could condense on the internal mechanism,
making correct operation impossible. To prevent this,
or if this occurs, leave the player for one or two hours
with the power turned on, then turn the power off and
on again.
1.4.2 Never use a stabilizer or printable
discs
Using commercially available CD stabilizers or
printable recordable discs with this player will dam-
age the mechanism and cause it to malfunction.
NOTE
Never use a disc that has had a stabilizer mounted to
it. The residual adhesive may cause the disc to stick
to the mechanism of the CD-RW2000. If it sticks to
the mechanism, you will need a technician to get it
out.
1.4.3 Handling of compact discs
Observe the following:
• Always place the compact discs in the trays with
their label facing upward (compact discs can only
be played on one side).
• To remove a disc from its storage case, press down
on the center of the case, and lift the disc out, hold-
ing it carefully by the edges.
• Finger marks and dust should be carefully wiped
off the disc’s recorded surface with a soft cloth.
Unlike conventional records, the compact disc has
no grooves to collect dust and microscopic debris,
so gently wiping with a soft cloth should remove
most particles.
• Wipe in a straight motion from the inside to the
outside of the disc. Small dust particles and light
stains will have absolutely no effect on reproduc-
tion quality.
• Never use such chemicals as record sprays, anti-
static sprays or fluid, benzine or thinner to clean
compact discs. Such chemicals will do irreparable
damage to the disc’s plastic surface.
• Discs should be returned to their cases after use to
avoid serious scratches that could cause the laser
pickup to “skip”.
• Don’t expose discs to direct sunlight or high
humidity and temperature for extended periods.
Long exposure to high temperature can warp the
disc.
• Only use circular compact discs. Avoid using non-
circular promotional, etc. discs.
• To keep the laser pickups clean, don’t touch them.
For the same reason, don’t leave the disc trays
opened unnecessarily.
1.4.4 Additional notes with regard to
CD-R and CD-RW discs
There are additional precautions that you should take
when handling CD-R and CD-RW discs, that are dif-
ferent to those that you should take when handling
ordinary CDs.
• Avoid touching the recording (non-label) side of a
disc on which you will be recording. Recording on
a disc requires a cleaner surface than playing back,
and fingerprints, grease, etc. can cause errors in the
recording process.
• CD-R discs are more sensitive to the effects of heat
and ultraviolet rays than ordinary CDs. It is impor-
tant that they are not stored in a location where
direct sunlight will fall on them, and which is away