Filter
Top Products
61
GB
NAS-E35HD.GB.3-292-247-11(1)
Tracks cannot be played back.
Only tracks in the MP3 (“.mp3”), WMA
(“.wma”) and AAC (“.m4a”) format can be
played on this unit. Tracks in other formats
cannot be played (page 35).
USB device formatted with le systems other
than FAT16 or FAT32 are unsupported.*
1
If you use partitioned USB device, only MP3,
WMA and AAC tracks on the rst partition
can be played.
Playback is possible up to 8 levels.
e number of folders has exceeded 999.
e number of tracks has exceeded 999.
Files that are encrypted or protected by
passwords, etc. cannot be played back.
*
1
is unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For details, see
the operation manual of each USB device or contact the
manufacturer.
Timer
The Play Timer or Recording Timer does not
work.
Set the clock correctly (page 21).
A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
e unit is being subjected to shocks or
vibrations. Place the unit at a stable location.
The contents recorded by the Recording
Timer is not complete. Some of the material
at the beginning or in the middle are
missing.
Set the clock correctly (page 21).
A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
e unit was subjected to shocks or vibrations.
Place the unit at a stable location.
Title Update
Title Updater cannot be used on the
computer.
Use a USB storage device supported by the
unit (page 71).
An error occurs when you run Title Updater
on the computer.
Close Virtual Expander (MICROVAULT
soware) rst, and then run “TitleUpdater.
exe” again.
“export.dat” le cannot be exported.
Only album information (audio data)
recorded from audio CDs can be exported.
Album information that has been imported
using the Title Updater cannot be exported.
Make sure that the USB storage device is
connected rmly to the unit.
You have disconnected the USB storage device
before “Device Stop” appears on the unit’s
display.
The USB storage device or Title Updater is
not recognized by the computer.
Disconnect the USB storage device, and then
reconnect it correctly.
The “import.dat” le cannot be saved.
e USB storage device is full. Delete
unnecessary data from the USB storage device.
e USB storage device is write-protected.
Undo the write-protection.