Sony Ericsson NAS-E35HD Stereo System User Manual


 
33
GB
NAS-E35HD.GB.3-292-247-11(1)
To reduce static noise during
reception of a weak FM stereo station
Press FM MODE repeatedly until “MONO”
appears in the display to switch the stereo
reception to monaural.
To change the AM tuning interval
e AM tuning interval is factory set to 9 kHz
(or 10 kHz for some areas; this function is not
available on the European model).
1
Tune in any AM station, and then press
 to turn o the unit.
2
Press DISPLAY to display the clock.
3
While pressing and holding TUNE + on the
main unit, press  on the main unit.
All the preset AM stations are erased. To reset
the interval to the factory setting, do the same
procedure.
Notes on listening to the DAB service

When tuning in a DAB service, it may take a few
seconds before you hear any sound.

Primary service is automatically received when
secondary service ends.
Presetting radio stations or
DAB services*
By presetting FM stations, AM stations or DAB
services*, you can easily tune them in later merely
by selecting the corresponding preset number.
You can preset up to 20 FM stations or DAB
services and up to 10 AM stations.
* For the UK model only
1
Turn in the desired radio station
or DAB service (“Selecting a radio
station or a DAB service” on page
32).
2
Press TUNER MEMORY.
3
Press +/– to select a preset number,
and then press ENTER.
4
Repeat steps 1 to 3 to store other
stations or services.
e preset stations or services are retained
for about half a day even if you disconnect
the power cord or if a power failure occurs.
To listen to the preset station or
service
1
Press TUNER/BAND repeatedly to select
“DAB”, “FM”, or “AM”.
2
Press TUNING MODE repeatedly until
“PRESET” appears in the display.
3
Press +/– to select the preset station.
Tip
You can select the preset station using the numeric
buttons on the remote control.
For example, when you select the station which preset
number is 15, press 1 and 5, and then press ENTER.
If you enter unavailable preset number, “––” appears in
the display and you cannot select the station.