Filter
Top Products
16
GB
•RETRY?
Appears to ask you to re-measure or exit
without re-measuring when the
measurement fails.
• CANCEL
Appears when you cancel auto calibration
during the measurement.
* TSP (Time Stretched Pulse)
A TSP signal is a highly precise measuring signal
that utilizes impulse energy, measuring a wide
band, from low to high, in a short period.
The amount of energy used to measure signals is
important to ensure measurement accuracy in a
normal indoor environment. Using TSP signals
makes it possible to measure signals effectively.
x CAL TYPE
(Parameter type)
• ENGINEER
Sets the frequency to one that matches that
of the Sony listening room standard.
•FULL FLAT
Makes the measurement of frequency from
each speaker flat.
x EQ CURVE EFFECT
(Activates/deactivates the EQ
curve measurement)
•OFF
Deactivates the EQ curve measurement.
•ON
Activates the EQ curve measurement.
After the measurement is completed, this
setting is set to ON automatically.
Notes
• DTS 96/24 signals are played back as 48 kHz
signals when EQ CURVE EFFECT is set to “ON.”
When you play back DTS 96/24 signals, set this
item to “OFF” and set the DIRECT function to
“ON” (page 10, 12).
• You cannot select this setting before saving the
measurement results (factory setting).
Settings for the amplifier
By using the System Settings menus, you can
make various adjustments to customize the
amplifier.
1 Press MENU.
2 Press U to display “<1-System
Settings>,” then press ENTER
to enter the menu.
3 Press U/u repeatedly to display
the parameter you want to
adjust.
4 Press ENTER to enter the
parameter.
5 Press U/u repeatedly to select
the setting you want to adjust.
6 Press ENTER to enter.
7 Repeat steps 3 to 6 when you
want to make other settings.
To return to the menu one level
up
Press I.
To exit the menu
Press MENU.
Note
Some parameters and settings may appear dimmed
on the display. This means that they are either
unavailable or fixed and unchangeable.