Filter
Top Products
STR-DE995/895 4-244-963-11(1)GB
61
GB
Operations Using the Remote RM-LG112
Programming the remote
You can program the remote to control non-
Sony components by changing the code. Once
the control signals have been memorized, you
can use those components as part of your
system.
Furthermore, you can also program the remote
for Sony components that the remote is unable
to control. Note that the remote can only
control components that accept infrared
wireless control signals.
1 Press AV ?/1 while pressing down USE
MODE.
The indicator lights and IR SET appears in
the display.
2 Push the scroll key/PUSH towards v or
V to select the input selector (including
TV ?/1) for the component you want to
control.
For example, if you are going to control a
CD player, select CD/SACD.
3 Press PUSH.
4 Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables on pages 62–64 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
5 Press ENTER.
Once the numeric code has been verified,
the indicator slowly flashes twice and the
remote automatically exits the programming
mode.
Selecting the command
mode of the remote
Set the remote command mode using the USE
MODE button and scroll key/PUSH.
Selecting the command mode
You can switch the command mode (AV1 or
AV2) of the remote. If the command mode of
the receiver and the remote is different, you
cannot use the remote to operate the receiver.
1 Press ?/1 while pressing down USE
MODE.
2 Push the scroll key/PUSH towards v or
V to select “MAIN”.
3 Press PUSH.
4 Push the scroll key/PUSH towards v or
V to select “AV1” or “AV2”.
5 Press PUSH.
The indicator lights once (twice for AV2),
then the command mode switches. You will
be able to see your selection (AV1 or AV2)
in the display.
To reset the remote to factory
settings
Press =/1, AV =/1, and MASTER VOL – at
the same time.
The indicator lights 3 times, then goes off.
continued