Filter
Top Products
8
Getting Started
Speaker placement for STR-DE915
For the best possible surround sound, we recommend:
• The best quality speakers possible
• Front, center, and rear speakers of equivalent size
and quality
• Positioning of speakers at the same distance from the
listening position (A).
The center speaker, however, may be moved closer,
but not beyond the straight line connecting the two
front speakers (B). The rear speakers may also be
closer to listening position than the front speakers (C),
to suit the configuration of your room. If the surround
effect is still inadequate, adjust the CENTER DELAY
and REAR DELAY parameters (see page 19).
A
C C
A
45°
90°
20°
B
Notes
• Do not place the center or rear speakers farther away from
the listening position than the front speakers.
• When mounting the rear speakers on side walls
perpendicular to the listening position they should be
placed 60 - 90 cm above the listening position (as shown
below in “Speaker placement for STR-DE715/DE615/
D660Z/D560Z”).
Depending on the shape of your room (etc.), you may
wish to place the rear speakers behind you instead of
on the side walls. One advantage of this placement is
that you can use a pair of large floor standing speakers
matching your front speakers.
A
C C
A
45°
90°
20°
B
Selecting the speaker system
If you connect only one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front speakers, see the following:
Note
If you place the rear speakers behind you, be sure to
check the speaker location setting in the SPEAKER
SETUP menu when using VIRTUAL MULTI REAR
and VIRTUAL REAR SHIFT sound fields (see pages 19
and 24 for details).
Speaker placement for STR-DE715/DE615/
D660Z/D560Z
For optimum surround sound effect, place your
speakers as shown below.
Selecting the impedance
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you’re not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
If nominal impedance of
your speaker is
Set IMPEDANCE SELECTOR to
8 ohms or higher
4 Ω
8 Ω
Between 4 and 8 ohms
Set SPEAKERS selector to
*
Do not use A+B with SOUND FIELD set to ON.
A
B
A+B
*
To drive
Speaker system A (connected
to the FRONT SPEAKERS A
terminals)
Speaker system B (connected
to the FRONT SPEAKERS B
terminals)
Both speaker systems A and B
(parallel connection)
Rear speaker
60 - 90 cm
Front speaker
45°