Filter
Top Products
MHC-GZR33Di/LBT-LCD7Di.GB.4-143-233-11(1)
115
GB
Additional Information
“OVER CURRENT” appears.
A p
roblem has been detected with the
level of electrical current from the
(USB) port. Turn o the system and
remove the USB device from the
(USB) port. Make sure there is no
problem with the USB device. If this
display pattern persists, contact your
nearest Sony dealer.
There is no sound.
e USB device is not connected
correctly. Turn o the system and
reconnect the USB device, then turn
on the system and check if “USB
MEMORY” lights up.
There is noise, skipping, or distorted
sound.
T
urn o the system, then reconnect the
USB device.
e music data itself contains noise,
or the sound is distorted. Noise may
have entered during the transfer or
recording process. Delete the le, and
try transferring or recording again.
e bit rate used when encoding audio
les was low. Send audio les with
higher bit rate to the USB device.
The USB device cannot be connected
into the
(USB) port.
e USB device is being connected
backwards. Connect the USB device in
the correct orientation.
“READING” is displayed for an
extended time, or it takes a long time
before playback starts.
e reading process can take a long
time in the following cases.
ere are many folders or les on the
USB device.
e le structure is extremely
complex.
e memory capacity is excessive.
e le size is extremely large.
e internal memory is fragmented.
us, we recommend following these
guidelines.
T
otal folders on USB device: 200 or
less
T
otal les per folder: 150 or less
Erroneous display
S
end the music data to the USB device
again, as the data stored in the USB
device may have been corrupted.
e character code that can be
displayed by this system are as follows:
Upper cases (A to Z)
Numbers (0 to 9)
Symbols (< > * +, ? / [ ] \ _)
Other characters appear as “_.”
Continued