Filter
Top Products
20
MZ-E505
6. If NG in the overall MO adjustments, return to Reset NV and
perform the adjustment again.
LCD display
XXX: NG item No.
7. If OK through the overall MO adjustments, press x key to
return to the TEST MODE and terminate the Overall Adjust-
ment mode.
LCD display
5-5-3.Resume clear method
1. Setting the testmode.
2. Set the Manual mode and set the item No.041 (NoClock).
LCD display
3. Press the X key.
LCD display
5-5-5. Overall CD and MO adjustment items
1. Overall offset adjustment
Item No. Contents
030 GRV setting • Sarvo OFF • Head UP
035 Laser ON/OFF electrical offset difference
measurement
Completed
2. Overall CD adjustment items
Item No. Contents
761 VC,VR power voltage High/Low selection
300 HPIT setting • Sarvo OFF
561 SLED move to inside
562 SLED move to outside
High reflection CD electrical offset adjustment
312
Laser ON • Focus UP • VC correction ALFA offset
adjustment
313 IJ offset adjustment
314 FE offset adjustment
HPIT adjustment
320 Focus servo ON
324 TE offset adjustment 1
321 TE gain adjustment
328 TWPP gain adjustment
324 TE offset adjustment 1
332 TE offset adjustment 2
330 Tracking servo ON
336 ABCD gain adjustment
337 KF gain correction
338 RF gain adjustment
344 CD focus gain adjustment
345 CD tracking gain adjustment
521 CD two-axis sensitivity adjustment (inside)
522 CD two-axis sensitivity adjustment (outside)
300 HPIT setting • servo OFF
completed
000 MO OK
000 XXX NG
041 NoClock
041 Res ***
041 ResClr
After reset is completed
LCD display
3. Overall MO adjustment items
Item No. Contents
761 VC,VR power voltage High/Low selection
100 G RV setting
Low reflect MO offset adjustment
112 Laser ON • Focus UP • EVC correction ALFA offset
adjustment
113 IJ offset adjustment
114 FE offset adjustment
118 Wpp denominator adjustment
HPIT adjustmet
200 LPIT setting • servo OFF
561 SLED move to inside
220 Focus servo ON
224 TE offset adjustment 1
221 TE gain adjustment
224 TE offset adjustment 1
232 TE offset adjustment 2
5-5-4. Rewrite the NV value
After resume clear, rewrite the NV value.
Item NO. NV value
861 0F (h)
862 0B (h)
863 C7 (h)
864 01 (h)
865 64 (h)
866 10 (h)
867 65 (h)
868 05 (h)