Filter
Top Products
14
MZ-E505
4-4. MANUAL MODE
4-4-1. Outline of the function
The Manual mode is designed to perform adjustments and
operational checks on the set’s operation according to each
individual function.
Usually, no adjustments are made in this mode.
However, the Manual mode is used to clear the memory before
performing automatic adjustments in the Overall Adjustment mode.
4-4-2. How to set the Manual mode
1. Set the TEST MODE and turn the control towerd VOL + to set
the Manual mode.
Remote control LCD display
2. During each test, turn and hold the control towerd > N or
. for a while to move the optical pickup on the sled outer or
inner perimeter.
000 Manual
Change Major
Item
Change Middle
Item
Change Minor
Item
Change Adjustment
Value
Write Adjustment
Value
.
: 100th place of mode number
increase
: 100th place of mode number
decrease
: 10th place of mode number
increase
: 10th place of mode number
decrease
: Up
: Down
key : When adjusted value is changed :
Adjusted value is written.
When adjusted value is not changed :
That item is adjusted automatically.
key
x
key
x
> N
> N
: Unit place of mode number
increase
: Unit place of mode number
decrease
> N
X
VOL
+
VOL
VOL
+
VOL
VOL
+
VOL
Test Mode
(Display Check Mode)
Manual Mode
Servo Mode
Audio Mode
Power Mode
OP Alignment Mode
key
x
x
>B
key
x
key
.
x
key
Overall Adjustment Mode
Sound Skip Check Result Display Mode
Self-diagnostic Display Mode
Key Check Mode
DISPLAY key
DISPLAY key
(Press and hold down about 3 sec)
Terminate key checking or open
the top panel.
VOL
+
VOL
+
VOL
4. During each test mode, the display is changed from one to
another each time DISPLAY key is pressed.
• Address & Adjusted Value Display
LCD display
• Jitter Value & Adjusted Value Display
LCD display
• Block Error Value & Adjusted Value Display
LCD display
• ADIP Error Value & Adjusted Value Display
LCD display
• Item Title Display
LCD display
Note: In the Power mode, the item title display is only displayed.
3. Each test item is assigned with a three-digit item number. The
100th place is a major item, 10th place is a middle item, and unit
place is a minor item.
011 XXXS5E
address
mode number
adjusted value
011 OFEJ5E
jitter value
mode number
adjusted value
011 063B5E
block error value
mode number
adjusted value
011 072A5E
ADIP error value
mode number
adjusted value
011 LrefPw 5 E
item title
mode number
adjusted value
4-3. TEST MODE STRUCTURE