Filter
Top Products
– 22 –
7. If NG, set the manual mode. Perform automatic adjustment
for the items not accepted. (See page 14)
• Overall CD adjustment items
Item No. Contents
312
313 CD electrical offset adjustment
314
328 CD TWPP gain adjustment
321 CD TE gain adjustment
323
CD TE offset adjustment
332
336 CD ABCD level adjustment
344 CD focus gain adjustment
345 CD tracking gain adjustment
521
CD two-axis sensitivity adjustment
522
341 CD focus bias adjustment
8. If CD adjustment is OK, insert an available SONY MO disc
(recorded).
At this time, be sure to turn OFF the disc protect switch.
9. Press
N key. The system discriminates between CD and MO
and performs automatic adjustment for the MO disc.
Also, if
. key is pressed, MO is adjusted automatically.
However, when CD adjustment is not finished, “SetCD!” is
blinking on the LCD and MO adjustment is not executed.
10. If the result of automatic adjustment is OK, the following dis-
play appears in the LCD:
11. If the result of automatic adjustment is NG, the following dis-
play appears in the LCD:
12. If NG, set the manual mode. Perform automatic adjustment
for the items not accepted. (See page 14)
LCD display
MO OK
141
LCD display
###: Overall adjustment. NG mode number
### NG
5-6. TEMPERATURE CORRECTION
• Adjustment Method of temperature correction
1. Select the manual mode of test mode, and set the mode num-
ber 014. (See page 14)
2. Measure the ambient temperature.
3. Adjust with
[VOL +], [VOL --] key so that the adjusted value
(hexadecimal value) becomes the ambient temperature.
(Initial value: 14h = 20 °C, Adjusting range: 80h to 7fh (–128
°C to +127 °C)
4. Press the X key to write the adjusted value.
5-7. OVERALL ADJUSTMENT MODE
• Adjustment Method of Overall Adjustment Mode
1. Setting the test mode. (See page 13)
2. Press the
. or [VOL --] key activates the overall adjust-
ment mode where the LCD display as shown below.
3. Insert the CD test disc TDYS-1 (Parts No.4-963-646-01) or an
available SONY CD disc.
4. Press
N key. The system discriminates between CD and MO
and performs automatic adjustment for CD.
Also, if
> key is pressed, CD is adjusted automatically.
5. If the result of automatic adjustment is OK, the following dis-
play appears in the LCD:
SetTmp
014
LCD display
LCD display
Assy**
000
: (DISC MARK) When power adjustment “H” finished;
Outward ON
When power adjustment “L” finished;
Inward ON
Power supply is not yet adjusted unless both outward
and inward disc marks are ON.
Note: Disc mark is displayed on the remote commander
LCD only.
**
CD auto adjustment information
F : CD auto adjustment finished
1 : Manual adjustment remains (not auto adjustment
)
0 : Not adjusted yet
MO auto adjustment information
F : Auto adjustment finished
1 : Manual adjustment remains
0 : Not adjusted yet
LCD display
CD RUN
%%%
%%%: Manual mode number being executed
LCD display
CD OK
341
LCD display
###: Overall adjustment. NG mode number
### NG
LCD display
%%%: Manual mode number being executed
MO RUN
%%%
6. If the result of automatic adjustment is NG, the following dis-
play appears in the LCD: