Filter
Top Products
Chapter 1: Setting Up
6
Inserting the
Battery
Install a lithium battery in the supplied
remote for remote control.
1 Slide out and remove the battery case.
2 Insert a lithium battery CR2025 with the
+ side facing up.
3 Insert the battery case.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommend by the manufacturer.
Discard used batteries according to the
manufacturer's instructions.
Battery life
You can expect the remote to operate for
about six months (using a Sony CR2025
lithium battery) before the battery run
down. When the battery no longer operates
the remote, replace the battery with a new
one.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the battery to avoid
damage caused by corrosion from battery
leakage.
Notes on lithium battery
•Keep the lithium battery out of the reach
of children.
Should the battery be swallowed,
immediately consult a doctor.
•Wipe the battery with a dry cloth to
assure a good contact.
•Be sure to observe the correct polarity
when installing the battery.
•Do not hold the battery with metallic
tweezers, otherwise a short-circuit may
occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose
of in fire.
Setting the Clock
The built-in clock shows the time in the
display even when the power is off.
Use the buttons on the unit for this
operation.
1 Press CLOCK.
2 Set the current hour by turning the JOG
dial until the correct hour appears.
3 Press ENTER/YES.
The minute indication begins flashing.
4 Set the current minute by turning the
JOG dial until the correct minute
appears.
5 Press ENTER/YES.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
To check the time while power is on
Press CLOCK.
The current time is displayed for 4 seconds.
To correct the clock setting
With the power turned off, repeat steps 1
through 5.
With the power turned on, press CLOCK
twice and repeat steps 2 through 5.
1
3,5
2,4
flashing
flashing
flashing
flashing
a lithium battery
CR2025