Sony MJ-L1 Stereo System User Manual


 
2
English
WARNING
To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
Do not install the appliance in a confined
space, such as a bookcase or built-in
cabinet.
U.S. and foreign patents licensed from
Dolby Laboratories Licensing Corporation.
Laser component in this product is
capable of emitting radiation exceeding
the limit for Class 1.
Owner’s Record
The model and serial numbers are located
on the rear panel.
Record the serial number in the space
provided below. Refer to them whenever
you call upon your Sony dealer regarding
this product.
Model No. MJ-L1
Serial No. __________________
INFORMATION
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If thisequipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
CAUTION
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
Note on CATV system installer:
This reminder is provided to call CATV
system installer’s attention to Article 820–40
of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable entry
as practical.
CAUTION
The use of optical instruments with this
product will increase eye hazard.
NOTICE FOR THE
CUSTOMERS IN THE U.S.A.
This symbol is intended to
alert the user to the presence
of uninsulated “dangerous
voltage” within the
product’s enclosure that
may be of sufficient
magnitude to constitute a
risk of electric shock to
persons.
This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the
appliance.
This appliance is classified as a CLASS 1
LASER product. The CLASS 1 LASER
PRODUCT MARKING is located on the
rear exterior.
The following caution label is located inside
the unit.
Welcome!
Thank you for purchasing the Sony Flat
Component System. This series is packed
with fun features. Here are just a few:
•A preset feature, that lets you store and
recall up to 30 of your favorite radio
stations
•A timer that lets you set the CD player,
MD deck or radio to turn on and off
whenever you want
•An MD deck that lets you record from the
radio or CD player
•A remote that lets you control your
system from your seat
The MJ-L1 consists of the following:
-Main unit : HCD-MJ1
-Speaker System : SS-MJ1
-Remote Control : RM-SMJ1
Before Using This
Unit
Make sure to take out the
sheet inside the disc slot
on the MD deck.
1 Connect the AC power cord to the wall
outlet and press POWER.
2 Press MD § to open the lid.
3 Remove the adhesive tape and take out
the sheet inside the disc slot.
The sheet may come out by itself when
you remove the adhesive tape.
Before setting up the system, press MD §
to close the lid, press POWER to turn off
the power, and disconnect the AC power
cord.
NOTICE FOR THE
CUSTOMERS IN CANADA
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE
EXPOSURE.
MD §
Remove tape
Take out sheet
POWER