Filter
Top Products
Chapter 4: Recording on MDs
17
Marking Track Numbers
Automatically
(level synchro function)
You can mark track numbers automatically
even when recording from an analog
source. The MD deck marks a new track
number if the signal level is continuously at
or below a certain fixed level for 2 seconds
or more, and then exceeds that level.
1 Press REC (or MD r REC on the
remote).
The REC PAUSE indicator flashes and
the MD deck stands by for recording.
2 Press EDIT/NO repeatedly until
“LevelSync?” appears in the display
3 Press ENTER/YES.
“LevelSync ON?” appears in the
display.
4 Press ENTER/YES.
“LEVEL-SYNC” appears in the display.
5 Starts recording.
Note
This setting is stored in the unit. Release it
after recording.
To cancel level synchro
1 Press EDIT/NO until “LevelSync?”
appears during recording or recording
pause.
2 Press ENTER/YES.
“LevelSyncOFF?” appears in the display.
3 Press EDIT/YES.
“LEVEL-SYNC” disappears in the
display.
POWER m ON
251
3,4
REC
TOC
MD
1
VOLUME