Filter
Top Products
32
Naming a group (MDS-JE770 only)
(continued)
5
Turn AMS (or press
./>
repeatedly) until “Gp
**
(selected group
number)” flashes, then press AMS or
YES.
“Complete!” appears.
Note
You cannot erase the name of a group that does not
have any tracks registered.
This function allows you to create a new group
and register a track or consecutive tracks which
are not already registered into that group. You
can also create groups without registering any
tracks.
1
While the deck is stopped, press
GROUP ON/OFF.
The GROUP ON/OFF button lights up.
2
Press MENU/NO.
“Edit Menu” appears in the display.
3
Turn AMS (or press
./>
repeatedly) until “Gp Create?” appears,
then press AMS or YES.
4
Do steps 4 to 8 of “Naming a track or an
MD using the controls on the deck” on
page 29 or steps 2 to 5 of “Naming a
track or an MD using the remote” on
page 30.
5
Turn AMS (or press
./>
repeatedly) to select the first track you
want to register, then press AMS or
YES.
6
Turn AMS (or press
./>
repeatedly) to select the last track you
want to register, then press AMS or
YES. (When registering only one track,
simply press AMS or YES again without
performing any other operations.)
“Complete!” appears for a few seconds and
the tracks are registered into the new group.
Tips
•
To create a group without registering any tracks, turn
AMS (or press
./>
repeatedly) until “None”
appears, then press AMS or YES.
“Complete!” appears for a few seconds and new
group is created.
•
You can also register tracks that were recorded on a
system that does not support the Group function.
Notes
•
You cannot register the same track to multiple
groups.
•
If all the tracks on an MD are registered into groups,
“Assign None” appears after step 4 and you cannot
register tracks.
•
When creating a group without registering any
tracks, you must enter the group name.
•
If you do not enter a group name in step 4,
“Group ** (group number)” appears instead of the
group name.
These functions allow you to release group
registrations simply by specifying the group for
which you want to release the registrations. In
addition, you can also release the group
registrations of all tracks on an MD at once.
Releasing a single group
— Group Release Function
You can release the group registrations of all
tracks within the specified group and erase that
group. (However, note that the tracks are not
erased.)
1
While the deck is stopped, press
GROUP ON/OFF.
The GROUP ON/OFF button lights up.
2
Press GROUP SKIP repeatedly until the
group you want to release appears.
3
Press MENU/NO.
“Edit Menu” appears in the display.
4
Turn AMS (or press
./>
repeatedly) until “Gp Release?”
appears.
Registering recorded
tracks into a new group
(MDS-JE770 only)
— Create Function
Releasing group
registrations (MDS-JE770
only)
— Release Function