Filter
Top Products
Playing MDs
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
23
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
masterpage:Left
(3 column)
3
Turn AMS (or press
./>
repeatedly) until “Setup?” appears,
then press AMS or YES.
4
Turn AMS (or press
./>
repeatedly) until “Program?” appears,
then press AMS or YES.
5
Turn AMS (or press
./>
repeatedly) until the track number you
want to add to the program appears,
then press AMS or
M
(or use the
number button(s) on the remote to enter
the track directly).
If you entered the wrong track number
Press
m
/
M
repeatedly until the wrong
track number flashes, then do step 5 above
again or press CLEAR to erase the track
number. If “0” flashes, press
m
so that the
last track number flashes, then enter a
correct number.
To enter a track number over 10
Use >10. For details, see page 21.
6
Repeat step 5 to enter other tracks.
The entered track is added to the location
where the “0” flashes.
Each time you enter a track, the total
program time appears in the display.
7
Press YES.
“Complete!” appears and the program is
completed.
8
Press
H
.
Program Play starts.
To stop Program Play
Press
x
.
Notes
•
If you eject the MD, the program will be lost.
•
The display shows “- - - . - -” when the total playing
time of the program exceeds 999 minutes.
•
If you press GROUP ON/OFF to turn on or off the
Group function, the program will be lost (MDS-
JE770 only).
Checking the order of the program
While the deck is stopped and “PGM”
lights up, press LEVEL/DISPLAY/CHAR (or
DISPLAY) repeatedly.
The first several tracks in the program appear in
the display. To see the rest of the program, turn
AMS (or press
>
repeatedly).
Changing the contents of the
program
While the deck is stopped and “PGM” lights up,
do steps 2 to 4, followed by one of the
procedures below:
To Do the following:
Erase a track Press
m
/
M
repeatedly
until the number of the
unwanted track flashes, then
press CLEAR.
Erase all tracks Press down CLEAR until all
the track numbers disappear.
Add a track at the
beginning of the
program
Press
m
repeatedly until
“0” flashes before the first
track number, then do steps
5 to 7.
Add a track in the
middle of the program
Press
m
/
M
repeatedly
until the track number which
will precede the new track
flashes. Press AMS to
display flashing “0,” then do
steps 5 to 7.
Add a track to the end
of the program
Press
M
repeatedly until
“0” flashes after the last
track number, then do steps
5 to 7.
Replace a track Press
m
/
M
repeatedly
until the number of the track
to be changed flashes, then
do steps 5 to 7.