Filter
Top Products
Editing Recorded MDs
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
29
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
masterpage:Left
(3 column)
4
Turn AMS (or press
./>
repeatedly) until the new track position
appears, then press AMS or YES.
“Complete!” appears and the deck starts to
play the moved track.
Note
(MDS-JE770 only) When you move a track to a track
number that is registered into a group, the moved track
is re-registered into the group containing the move
destination track number. In addition, if you move a
track that is registered into a group to a track number
that is not registered into a group, the group
registration of the moved track is released. However,
when the Group function is on, you can only move
tracks within the selected group.
You can enter a name for a recorded MD as well
as for individual tracks. Names can consist of
uppercase and lowercase letters, numbers, and
symbols. A total number of about
1,700 characters can be stored for all the names
on the MD.
For MDS-JE770
The following procedure is for entering names
when the Group function is off. To name a
group, see “Naming a group (MDS-JE770
only)” on page 31.
However, when naming an MD recorded
using the Group function, be sure to
name the disc with the Group function
on so as not to rewrite the group
management information by mistake.
For details on the group management
information, see page 12.
Notes
•
If you name a track while it is being recorded, be
sure to finish the naming operation before the track
ends. If the track ends before you finish, the entered
character data will be discarded and the track will
remain unnamed.
•
If you enter the symbol “//” between the characters
in disc names such as “abc//def”, you may be unable
to use the Group function.
Naming a track or an MD
using the controls on the
deck
1
While the deck is stopped, playing,
recording, or paused, press MENU/NO.
“Edit Menu” appears in the display.
2
Turn AMS until “Nm In?” appears, then
press AMS or YES.
While the deck is recording, a flashing
cursor appears in the display and you can
enter a name for the track being recorded. In
this case, go to step 4.
3
Turn AMS until the track number (when
naming a track) or “Disc” (when naming
the MD) flashes, then press AMS or
YES.
A flashing cursor appears.
The deck starts playing and you can name a
track while monitoring the sound.
4
Press LEVEL/DISPLAY/CHAR
repeatedly to select the character type.
Each time you press the button, the display
changes cyclically as follows:
(Blank space)
t
A (Upper cases)
t
a
(Lower cases)
t
0 (Numbers)
t
’
(Symbols)
To enter a space
Press
M
while the cursor is flashing. You
cannot enter a space as the first character.
5
Turn AMS to select the character.
The selected character flashes.
To enter a symbol
You can use the following symbols in titles:
’ – / , . ( ) : ! ? & + < > _ = ” ; # $ % @ * `
To change a selected character
Repeat steps 4 and 5.
6
Press AMS.
The selected character is entered and lights
continuously. The cursor shifts to the right,
flashes, and waits for the input of the next
character.
Naming a track or an MD
— Name Function
continued