Filter
Top Products
Getting Started
9
GB
Inserting two R6 (size AA)
batteries into the remote
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Using the remote
You can use the buttons shown below to operate
a Sony TV.
Attaching the speaker pads
Attach the supplied speaker pads to the bottom
of the front and surround* speakers to stabilize
the speakers and prevent them from slipping.
Front speaker (Left (4)/Right (4))
Surround speaker (Left (4)/Right (4))*
* MHC-RV60 only
Notes
• Keep the speaker cords away from the antennas to
prevent noise.
• Do not place the surround speakers on top of a TV.
This may cause distortion of the colors in the TV
screen.
• Be sure to connect both left and right surround
speakers. Otherwise, the sound will not be heard.
To Do this
Turn the TV on or
off
Press TV ?/1.
Switch the TV’s
video input
Press TV/VIDEO.
Change the TV
channels
Press TV CH + or –.
Adjust the volume
of the TV speaker(s)
Press TV VOL + or –.
When carrying this system
Perform the following procedure to protect
the CD mechanism.
1 Make sure that all discs are removed
from the system.
2 Hold down CD and then press ?/1 until
“STANDBY” appears.
After “STANDBY” disappears, then
“LOCK” appears.
3 Unplug the power cord.
continued